General-tools-and-instruments HT20 Uživatelský manuál Strana 7

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 6
Display Legend
: indicates reading is higher than high alarm setpoint
for that parameter
: indicates reading is lower than low alarm setpoint
for that parameter
%RH: relative humidity unit
°C: Celsius temperature unit
°F: Fahrenheit temperature unit
[-]188.8: Humidity or temperture value or one of the
following four working status indications
LOG: Unit is logging data
- - -: Unit is in standby mode, ready to log data
FUL: Internal memory is full (and logging has been
stopped)
CON: Unit needs to be configured by software
SETUP INSTRUCTIONS
INSTALLING/REPLACING THE BATTERY
The HT20 uses a 3.6VDC “1/2 AA Lithium-ion battery.
To open the battery compartment, use a paper clip or a
screwdriver with a fine point to push in the silver flange
showing through the small square hole in the rear of the unit
7
Fig. 1b.
All possible
display
indications
on the HT20
LATCH
HT20 - Manual–FINAL_REV_0316121_awb 3/16/12 4:02 PM Page 7
Zobrazit stránku 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Komentáře k této Příručce

Žádné komentáře